User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
64
To install a 5G NR module:
1. Remove the screw from the M.2 standoff.
2. Align and insert the module into the slot.
3. Press down, and then secure it in place using the screw previously
removed.
4. (Optional) Connect the RF cables from the antennas to your module.
Make sure that the correct cable is attached to each of the connectors
by following chart on the next page.
NOTE:
• Refer to Installing antennas for more information on installing the
antennas.
• Connecting antennas to your module may strengthen the signal.
• A soft clicking sound indicates that the antenna has been securely
attached on the module.
ANT.1
ANT.1
ANT.2
ANT.3ANT.6
ANT.2
ANT.3
ANT.6