User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
60
3.7 Installing a wireless card to the
M.2 (E-key) slot
1. Remove the M.2 screw.
2. Align and insert the wireless card into the M.2 slot inside the
Embedded Computer.
3. Gently push down the wireless card on top of the standoff, and then
fasten it using the previously removed screw.
4. (Optional) Connect the RF cables from the antennas to your wireless
card. Make sure that the correct cable is attached to each of the
connectors by referring to the illustration on the next page.
NOTE:
• Please refer to the Installing antennas section for more
information on installing the antennas.
• Connecting antennas to your wireless card may strengthen the
wireless signal.
• A soft clicking sound indicates that the antenna has been securely
attached on the wireless card.
WARNING! RF modules are intended for OEM or host integrators only.
For availability of system level RF certication, check with your OEM
integrator.