User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
50
NOTE: The illustrations in this section are for reference only. The slots
may vary depending on model.
3.1 Removing the bottom cover
1. Turn off your Embedded
Computer then disconnect all
cables and peripherals.
2. Place the Embedded
Computer on a flat stable
surface, with its top side
facing down.
3. Remove the four (4) rubber
feet screws from the bottom
cover.
4. Remove the two (2) screws
securing the bottom cover.
5. After removing the screws,
remove the bottom cover and
place it aside.
IMPORTANT!
• Ensure that your hands are dry before proceeding with the rest
of the installation process. Before installing any of the features in
this guide, use a grounded wrist strap or touch a safely grounded
object or metal object to avoid damaging them due to static
electricity.
• Turn off the power of your Embedded Computer, and allow it to
cool for at least 10 minutes before performing any installation/
uninstallation process.