User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
33
14. DC-in 4-Pin Power connector
The DC-in 4-pin Power connector is for DC power input. Using a
compatible power cable and power board, you may connect a suitable
power supply with DC-in jacks.
Connector type
POWER CON 4P R/A
15. I2C connector
The I2C (Inter-Integrated Circuit) connector allows you to connect an
I2C-compatible IoT security module.
Connector type
Header 1x3p, K6, 2.0mm pitch