User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
27
7. Serial Port connector
The Serial (COM) Port connector allows you to connect a serial port
module. Connect the serial port module cable to this connector, then
install the module to a slot opening on the system chassis.
Connector type
BOX header 2x10p, K10, 2.0mm pitch
NOTE:
• The serial port module is purchased separately.
• COM1 and COM2 support RS-232/422/485.