User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
13
Antenna hole
The antenna hole allows you to connect a wireless
antenna to enhance wireless signal reception.
USB 2.0 port
The USB (Universal Serial Bus) port is compatible with
USB 2.0 and USB 1.1 devices, such as keyboards, pointing
devices, ash disk drives, external HDDs, speakers,
cameras, and printers.
Serial (COM) connector
The 9-pin RS-232 serial (COM) connector allows you to
connect devices that have serial ports, such as bar code
scanners, modems, and printers.
NOTE: This port also supports General Purpose Iput/
Output (GPIO) for customizing digital input/output.
1.1.2 Rear view