User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5-inch storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an M.2 B-key module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- Chapter 4: Watchdog Timer
- Appendix
11
USB 3.2 Gen 2 port
The USB 3.2 Gen 2 (Universal Serial Bus) port provides a
transfer rate up to 10 Gbit/s.
HDMI™ port
The HDMI (High Denition Multimedia Interface) port
supports a Full-HD device, such as an LCD TV or monitor,
to allow viewing on a larger external display.
Power switch
The power switch allows you to turn the Embedded
Computer on or o. You can use the power switch to
put your Embedded Computer to sleep mode or press it
for four (4) seconds to force shutdown your Embedded
Computer.
Dual-mode DisplayPort
This port allows you to connect your Embedded
Computer to an external display and supports DVI or
HDMI™ adapters.
Serial (COM) connector
The 9-pin RS-232/RS-422/RS-485 serial (COM) connector
allows you to connect devices that have serial ports, such
as bar code scanners, modems, and printers.