User Manual

Report No. ASL23051710
52 - 95
Universal Standard Service, Inc.
5.4.1.10.3
TABLE: Ball pressure test of thermoplastics
N/A
Allowed impression diameter (mm) .................................. :
 2 mm
⎯
Object/Part No./Material
Manufacturer/trademark
Test temperature (C)
Impression diameter (mm)
Supplementary information:
5.4.2.2,
5.4.2.4 and
5.4.3
TABLE: Minimum Clearances/Creepage distance
N/A
Clearance (cl) and creepage
distance (cr) at/of/between:
Up
(V)
U r.m.s.
(V)
Frequenc
y (kHz)
1
Required
cl (mm)
cl
(mm)
2
Required
3
cr (mm)
cr
(mm)
Supplementary information:
Note 1: Only for frequency above 30 kHz
Note 2: See table 5.4.2.4 if this is based on electric strength test
Note 3: Provide Material Group
5.4.2.3
TABLE: Minimum Clearances distances using required withstand voltage
N/A
Overvoltage Category (OV):
Pollution Degree:
Clearance distanced between:
Required withstand
voltage
Required cl
(mm)
Measured cl (mm)
Supplementary information:
5.4.2.4
TABLE: Clearances based on electric strength test
N/A
Test voltage applied between:
Required cl
(mm)
Test voltage (kV)
peak/ r.m.s. / d.c.
Breakdown
Yes / No
Supplementary information: