User Manual

Report No. ASL23051710
38 - 95
Universal Standard Service, Inc.
EN 62368-1
Clause
Requirement + Test
Result - Remark
Verdict
P.4.2 b)
Abrasion testing ................................................. :
N/A
P.4.2 c)
Mechanical strength testing ................................. :
N/A
Q
CIRCUITS INTENDED FOR INTERCONNECTION WITH BUILDING WIRING
P
Q.1
Limited power sources
P
Q.1.1 a)
Inherently limited output
P
Q.1.1 b)
Impedance limited output
P
- Regulating network limited output under normal
operating and simulated single fault condition
P
Q.1.1 c)
Overcurrent protective device limited output
N/A
Q.1.1 d)
IC current limiter complying with G.9
P
Q.1.2
Compliance and test method
(See appended table Annex Q.1)
P
Q.2
Test for external circuits – paired conductor cable
N/A
Maximum output current (A) ................................ :
⎯
Current limiting method ........................................ :
⎯
R
LIMITED SHORT CIRCUIT TEST
N/A
R.1
General requirements
N/A
R.2
Determination of the overcurrent protective device
and circuit
N/A
R.3
Test method Supply voltage (V) and short-circuit
current (A)). ...................................................... :
N/A
S
TESTS FOR RESISTANCE TO HEAT AND FIRE
N/A
S.1
Flammability test for fire enclosures and fire
barrier materials of equipment where the steady
state power does not exceed 4 000 W
N/A
Samples, material ............................................... :
⎯
Wall thickness (mm) ............................................ :
⎯
Conditioning (C) ................................................. :
⎯
Test flame according to IEC 60695-11-5 with
conditions as set out
N/A
- Material not consumed completely
N/A
- Material extinguishes within 30s
N/A
- No burning of layer or wrapping tissue
N/A