User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5โ storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
63
3.11 Installing the VESA mount
(optional)
1. Place your Embedded Computer upside down on a ๎at and stable
surface.
2. Attach the bundled two (2) 12mm screws into the screw holes at the
bottom of your Embedded Computer.
3. Remove the screw hole covers at the back of your VESA mount-
compatible device, if they exist.
You may install a VESA mount to your Embedded Computer, which allows
you to install your Embedded Computer to a VESA mount-compatible
device.