User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
60
5. Insert the bundled O-ring over the antenna jack (A), then secure the
antenna jack using one of the bundled hex screws (B).
6. Connect the other end of the RF connector and cable to your wireless
card (refer to Installing a wireless card to the M.2 (E-key) slot for
details) or to your WWAN card (refer to Installing an mPCIe / mSATA
module for details).
7. Replace the bottom cover. Refer to Replacing the bottom cover for
details.
8. Screw the external Wi-Fi antennas onto their corresponding antenna
jacks on the front and rear panels by turning them in a clockwise
direction.
9. Position the antennas for optimal signal reception.