User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
50
1. (Optional) Remove the mPCIe or mSATA card, if one is installed, by
removing the screw securing the mPCIe or mSATA card first, then
removing the mPCIe or mSATA card.
2. Push the nano SIM cover in the direction away from the SO-DIMM
slots.
3. Lift the nano SIM cover.
4. Place the nano SIM into the nano SIM slot.
5. Close the nano SIM cover.
6. Push the nano SIM cover towards the SO-DIMM slots to secure the
nano SIM card.
3.6 Installing a nano SIM card