User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing wall mount brackets (optional)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
27
8. SMBus connector
The System Management Bus (SMBus) connector allows you to connect
SMBus devices. This connector is generally used for communication
with system and power management-related tasks.
Connector type
Header 1x4p, 2.0mm pitch
9. GPIO connector
The GPIO connector allows you to connect a general purpose input/
output module to customize digital signal input/output.
Connector type
BOX header 2x5p, K9, 2.0mm pitch