User Manual

46
3.5 Installing antennas (optional)
You may install antennas to the ve (5) antenna jacks located on the front
and rear panels. The installed antennas can be connected to an LTE module
installed in the Mini PCIe/mSATA slot or to a wireless card installed in the
M.2 Wi-Fi slot.
To install an antenna:
NOTE: If your Embedded Computer came pre-installed with wireless
card antenna jacks, skip to step 8.
1. Remove the bottom cover. Refer to Removing the bottom cover for
details.
2. Prepare the RF connector and cable.
3. Remove the rubber caps from the antenna holes.
4. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards, ensuring that the at
edge of the jack is properly aligned to the at edge of the hole.
5. Insert the bundled O-ring over the antenna jack.
6. Secure the antenna jack using one of the bundled hex screws.