User Manual
Table Of Contents
- Safety information
- About this guide
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EzFlash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
ASUS EBS-A700
2-8
1. ATX Power connectors (24-pin ATXPWR, 2 x 4-pin EATX12V)
Correctly orient the ATX power supply plugs into these connectors and push
down rmly until the connectors completely t.
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
floating
GND
GND
GND
PSON#
GND
-12 Volts
+3 Volts
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
A
B
EATX12V
BA
ATX_PWR
PIN 1
GND
GND
GND
GND
+12V
+12V
+12V
+12V
Connector type
POWER CON 24P S/T
POWER CON 8P S/T
2. COM Debug header (COM_DEBUG)
This header allows connection to a COM Debug card.
COM_DEBUG
PIN 1
GND
GND
debug_control
TXD
+3V
The COM Debug Card is purchased separately.
Connector type HEADER 2x3p, K3, 2.54 mm pitch, S/T
2.5 Internal connectors