User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EzFlash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
H610A-IM-A
2-22
10. SATA 6.0Gb/s ports (7-pin SATA6G_1-4)
These ports connect to SATA 6.0 Gb/s hard disk drives or an optical drive via SATA
6.0 Gb/s signal cables.
SATA6G_3
A
SATA6G_4
B
SATA6G_1
C
SATA6G_2
D
A B
C D
GND
RSATA_RXP
RSATA_RXN
GND
RSATA_TXN
RSATA_TXP
GND
GND
RSATA_TXP
RSATA_TXN
GND
RSATA_RXN
RSATA_RXP
GND
11. General Purpose Input/Output header (GPIO_CON)
This header is for a general purpose input/output module which allows you to
customize the digital signal input/output.
+3V
GPIO7
GPIO5
GPIO3
GPIO1
GND
GPIO8
GPIO6
GPIO4
GPIO2
PIN 1
GPIO_CON
Connector type
WAFER HD 2x5p, 2.0mm pitch, S/T
Connector type
SATA CON 7P S/T