User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 Network Stack Configuration
- 3.3.11 USB Configuration
- 3.3.12 NVMe Configuration
- 3.3.13 Onboard Devices Configuration
- 3.3.14 Miscellaneous
- 3.3.15 APM Configuration
- 3.3.16 EzFlash
- 3.3.17 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
H610A-IM-A
2-20
7. System Panel header (10-1 pin F_PANEL)
This header supports several chassis-mounted functions.
• System power LED (2-pin +PWR_LED)
This 2-pin header is for the system power LED. Connect the chassis power LED cable
to this header. The system power LED lights up when you turn on the system power,
and blinks when the system is in sleep mode.
•
Hard disk drive activity LED (2-pin +HDD_LED)
This 2-pin header is for the HDD Activity LED. Connect the HDD Activity LED cable to
this header. The IDE LED lights up or flashes when data is read from or written to the
HDD.
•
ATX power button/soft-off button (2-pin PWR_BTN)
This 2-pin header is for the system power button.
•
Reset button (2-pin RESET)
This 2-pin header is for the chassis-mounted reset button for system reboot without
turning off the system power.
PIN 1
PWR_BTN
PLED+
PLED-
PWRBTN#_PANEL
GND
HDD_LED+
HDD_LED-
GND
O_RSTCON#_PR
NC
+PWR_LED
+HDD_LED RESET
F_PANEL
Connector type
HEADER 2x5p, K10, 2.54mm pitch