User Manual
Table Of Contents
- Notices
- Safety information
- Chapter 1
- Chapter 3
- BIOS setup
- 3.1 BIOS setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 PCI Express Configuration
- 3.3.6 CSM Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Configuration
- 3.3.9 SATA Configuration
- 3.3.10 USB Configuration
- 3.3.11 Onboard Devices Configuration
- 3.3.12 APM Configuration
- 3.3.13 EzFlash
- 3.3.14 Watchdog Timer
- 3.3.15 Network Stack Configuration
- 3.3.16 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
- BIOS setup
Chapter 2: Motherboard information
2-16
NOTE: The serial port cables are purchased separately.
3. COM Port headers (10-pin COM3 - COM8)
These headers are for serial (COM) ports. Connect the serial port cables to
these headers, then install the module to a slot opening at the back of the
system chassis.
PIN 1
RXD1
DTR1#
DSR1#
CTS1#
DCD1#
TXD1
GND
RTS1#
RI1#
PIN 1
COM6 COM5
COM3 COM4
COM8 COM7
CTS1#
DSR1#
DTR1#
RXD1
RI1#
RTS1#
GND
TXD1
DCD1#
E F
A
A B
C D
E F
B
C
D
Connector type
Header 2x5p, K10, 2.54mm pitch
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
4. USB 2.0 headers/connectors (10-pin USB56, USB78 / USB9, USB10)
These connectors are for USB 2.0 ports. Connect the USB cables to the
connectors. The USB connector complies with USB 2.0 specication that
supports up to 480 Mbps connection speed.
USB56
PIN 1
USB+5V
USB_P5-
USB_P5+
GND
NC
USB+5V
USB_P6-
USB_P6+
GND
C
C D
USB78
USB9 USB10
PIN 1
USB+5V
USB_P7-
USB_P7+
GND
NC
USB+5V
USB_P8-
USB_P8+
GND
D
A B
A B
Connector type
Header 2x5p, K9, 2.54mm pitch