User Guide

ADSL Modem/Router User’s Guide 23
User Name: Enter the name required to login to your service provider.
Password: Enter the password required to login to your service provider.
Confirm Password: Enter the password again.
Encapsulation Mode: Auto, LLC, VC MUX, VC MUX + HDLC
Get IP Address from: Service Provider - Remote server will automatically assign
WAN IP Address.
Customized - User can enter a WAN IP Address below.
WAN IP Address: Manually specify a WAN IP address (must also setup the De-
fault Gateway in the Routing Table Maintenance)
PPP startup status: Up - login to service provider after connection is established
Down - don’t login to service provider after connection is established
DOD: Enable - Bring up PPP when network activity is detected
Disable - Do not use dial-up on demand
Idle Timeout: Disconnect automatically when connected computers reach this
amount of inactivity time.
Function: NAT (Network Address Translation) - check to enable.
Click Submit after selections are completed and restart the modem.
NOTE: You must also setup the Ethernet Configuration and setup the Default Gate-
way in the Routing Table Maintenance (Default Gate required for manual WAN IP).
4. Basic Configuration