User Guide

34 Voice Gateway / Pocket Voice Gateway
5.4. Keypad Control
Voice Gateway / Pocket Voice Gateway can be controlled using the keypad
on the telephone set. Users can press special codes to set up the gateway.
The control codes are listed below:
5.4.1. Basic Commands
1. Set Speed Dial
## (Do) [1] (Do) [2–9 phone ID] (Do) [phone NO./IP][#] (Do) [0–2 :Ring Type] (Do----)
• When input IP, use * key to identify . (dot).
• Ring Type : 0 (Normal), 1(Fast), 2(Slow)
• Each phone can set 8 speed dial numbers
2. Read Speed Dial
## (Do) [2] (Do) [2–9 phone ID] (phone number will be spoken) (Do)
• You can repeat this operation to hear all telephone setting.
3. DHCP
Enable: ## (Do) [3] (Do) [1 to enable] (Do----)
Disable: ## (Do) [3] (Do) [0 to disable] (Do) then
[1] (Do) [ press IP][#], or
[2] (Do) [ press netmask][#], or
[3] (Do) [ press default gateway][#], or
[# ](Do----)
• If you make an entry error, press # to finish, and repeat any DHCP entry.
• If the parameter is changed, system will reboot (Voice Gateway Reboots Automatically)
5. System Configuration
(Do): Short Tone Sound
(Do----): Long Tone Sound