User Guide

Voice Gateway / Pocket Voice Gateway 27
5.2. Telnet Control
The Voice Gateway can be controlled by Telnet applications. This capabil-
ity is disabled when the voice gateway is already controlled from the con-
sole. Users may access all console commands using Telnet.
5.2.1. Establish Connection
Telnet can be used to enter the console control mode. The parameters of the
factory default are shown below. The default values using Telnet are:
IP Address = 192.168.100.100
Netmask = 255.255.255.0
Default Gateway = 192.168.100.254
You have to also enter a username (default “voip”) and password while you
use Telnet to connect to the system. The default password using Telnet is the
same as the console control input (last 6 lowercase characters of the Ether-
net MAC address). The console mode using the console cable has a higher
priority than using Telnet. Therefore, the Telnet user cannot enter control
mode while another computer has control through the console port. If a
currect Telnet session is active, it will be disconnected when a connection is
started through the console port. Except priority levels, there are no differ-
ences in commands when accessing through Telnet or the console port.
5.3. Web (HTTP) Console
Users can use browsers to setup or
show the information of the voice
gateway. For example, they can use
Internet Explorer to configure the
telephone number of VoIP phone.
The IP address of the Web console
is the same as the IP address used
by Telnet.
5. System Configuration
The web page is divided into several frames, each of which is related to a
VoIP module. It includes system settings, H.323 or MGCP settings, and
About. Users can follow the procedures listed below to set up Voice Gate-
way.