User Guide

16 Voice Gateway / Pocket Voice Gateway
1. When HyperTerminal is started, you
will be prompted to establish a new
connection. Follow the on-screen
instruction.
2. A user console connection do not
require dial-up information. Simply
choose the COM port that you are
using and then click OK.
3. Configure the COM port as shown
below. You are now ready to
configure the operation mode.
Recommended COM Port Settings:
Bit Rate: 9600 bps
Data Bits: 8
Parity Check: None
Stop Bit: 1
Flow Control: None
5.1.2. COM Port Configurations
To access the user console, use the console cable to connect the Console
port on the Voice Gateway to your PC’s empty COM port. Open a VT100
terminal emulation program such as Windows’ HyperTerminal to config-
ure the COM port. (The setup under HyperTerminal is given as an example
below.)
In Windows, click Start, Programs, Accessories, Communications, and
then select HyperTerminaI. When the HyperTerminal window appears,
double click the HyperTerminal icon to run it. If you cannot find it, add the
program using Add/Remove Programs in Control Panel.
5. System Configuration