User Guide

6
Wireless Cable Modem User’s Manual
Preparations
Before connecting the wireless cable modem to your PC, make sure your system is equipped
with a LAN controller or wireless LAN module and supports the TCP/IP protocol.
Installing a
Network Card
If your system does not have an embedded LAN controller, you must install a network interface
card as instructed below (assuming that you are using an Ethernet card under the operating
system of Windows 98):
1. Install an Ethernet card on your mother-
board.
2. Power up your PC and follow the Add New
Hardware Wizard’s instructions to install the
driver. When asked to restart your computer
at the end of the installation, click Yes.
3. After restarting the system, right-click
My Computer on the desktop, select
Properties, click the Device Man-
ager tab, and then double-click
Network adapters to confirm that the
Ethernet driver is properly installed.
System
Requirements