User Guide

ASUS CD-R/RW Drive User’s Manual 13
II. INSTALLATION
II. INSTALLATION
Drive
JUMPER
BLOCK
PC Configuration
After Installation
Existing PC
Configuration
Master Slave
Primary Port Hard Disk CD-ROM
Secondary Port CD-R/RW Drive —
Master Slave
Primary Port Hard Disk —
Secondary Port ——
CSM
S
POWER
CABLE
IDE DATA
CABLE
AUDIO
CABLE
(Analog)
AUDIO
CABLE
(Digital)
C) Hard-disc connected as Master to Primary IDE Port, CD-ROM connected
as Slave to Primary IDE Port: Connect the CD-R/RW Drive as Master to
Secondary IDE Port.
NOTE: Installation A is preferred for systems with an ID hard disk and CD-ROM drives.
For systems with only and IDE hard disk drive, Installation B is preferred.
5. Locate the free end of the IDE data cable and thread it out through the open
drive bay. Do the same with the power cable and the (optional) audio cable
(digital or analog). Your system will either be equipped with an analog or digital
soundcard connector. Use the appropriate connector on the drive recognizable
with the amount of pins.