User Manual

Chapter 2: Hardware Setup
2-24
FormoreBIOSupdateutilitiesinBIOSsetup,refertothesectionUpdating BIOS in
Chapter 4.
5. Waituntilthelightgoesout,indicatingthattheBIOSupdatingprocessiscompleted.
Refer to section Onboard LEDsformoreinformationoftheFlashbackLED.
• Donotunplugportabledisk,powersystem,orshorttheCLRTCjumperwhileBIOS
update is ongoing, otherwise update will be interrupted. In case of interruption, please
pressandholdtheBIOS_FLBKbuttonfor3secondsagaintorestarttheprocess.
• Ifthelightashesforvesecondsandturnsintoasolidlight,thismeansthatthe
BIOSFlashbackisnotoperatingproperly.Pleasecheckthefollowingwhenthis
happens:
- The USB drive should only contain a single partition.
 - TheUSBdriveshouldbeformattedtoaFAT32,FAT16,orNTFSlesystem.
 - TheBIOSlenameshouldbecorrectlynamed,andintherootfolderoftheUSB
drive.
- If the problem persists, the USB drive may not be compatible, please try another
USBdriveofadifferentbrand/model.
 ThenretrytheashbackbypressingtheBIOSashbackbuttonforthreesecondsuntil
theFlashbackLEDstartstoblink
.