User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 Onboard Devices Configuration
- 4.6.8 APM Configuration
- 4.6.9 USB Configuration
- 4.6.10 Network Stack Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 HDD/SSD SMART Information
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-26
You can disable the LAN controllers in BIOS. Due to hardware design, the LAN1 port’s
LEDs may continue to blink even when disabled.
* LAN ports LED indications
ACT/LINK
LED
SPEED
LED
LAN port
Activity Link LED Speed LED
Status Description Status Description
Off
No link Off 10 Mbps connection
Orange
Linked Orange 100 Mbps connection
Orange (Blinking)
Data activity Green 1 Gbps connection
Orange (Blinking
then steady)
Ready to wake up
from S5 mode
** Audio 2, 4, 5.1 or 7.1-channel configuration
Port
Headset /
2-channel
4-channel 5.1-channel 7.1-channel
Light Blue Line In Line In Line In Side Speaker Out
Lime Line Out Front Speaker Out Front Speaker Out Front Speaker Out
Pink Mic In Mic In Mic In Mic In
Orange – – Center/Sub woofer Center/Sub woofer
Black – Rear Speaker Out Rear Speaker Out Rear Speaker Out