User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Knowing BIOS
- 4.2 BIOS setup program
- 4.3 My Favorites
- 4.4 Main menu
- 4.5 Ai Tweaker menu
- 4.6 Advanced menu
- 4.6.1 Platform Misc Configuration
- 4.6.2 CPU Configuration
- 4.6.3 System Agent (SA) Configuration
- 4.6.4 PCH Configuration
- 4.6.5 PCH Storage Configuration
- 4.6.6 PCH-FW Configuration
- 4.6.7 Onboard Devices Configuration
- 4.6.8 APM Configuration
- 4.6.9 USB Configuration
- 4.6.10 Network Stack Configuration
- 4.6.11 NVMe Configuration
- 4.6.12 HDD/SSD SMART Information
- 4.7 Monitor menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Exit menu
- 4.11 Updating BIOS
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-24
For more BIOS update utilities in BIOS setup, refer to the section Updating BIOS in
Chapter 4.
5. Wait until the light goes out, indicating that the BIOS updating process is completed.
• Do not unplug portable disk, power system, or short the CLRTC jumper while BIOS
update is ongoing, otherwise update will be interrupted. In case of interruption, please
press and hold the BIOS_FLBK button for 3 seconds again to restart the process.
• If the light flashes for five seconds and turns into a solid light, this means that the
BIOS Flashback is not operating properly. Please check the following when this
happens:
- The USB drive should only contain a single partition.
- The USB drive should be formatted to a FAT32, FAT16, or NTFS filesystem.
- The BIOS filename should be correctly named, and in the root folder of the USB
drive.
- If the problem persists, the USB drive may not be compatible, please try another
USB drive of a different brand/model.
Then retry the flashback by pressing the BIOS flashback button for three seconds until
the Flashback LED starts to blink
.