User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis stand
- 2.2 Chassis cover
- 2.3 CPU installation
- 2.4 Cooling system installation
- 2.5 System memory
- 2.6 Assembly module
- 2.7 5.25-inch drive
- 2.8 Card reader
- 2.9 3.5” Storage devices
- 2.10 2.5” Storage device
- 2.11 Expansion slots
- 2.12 System fan
- 2.13 BIOS update utility
- 2.14 Motherboard rear and audio connection
- 2.15 Starting up for the first time
- 2.16 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 Trusted Computing
- 4.4.5 ACPI Settings
- 4.4.6 APM Configuration
- 4.4.7 Runtime Error Logging Settings
- 4.4.8 Onboard LAN Configuration
- 4.4.9 Serial Port Console Redirection
- 4.4.10 Intel TXT Information
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 WHEA Configuration
- 4.4.17 Tls Auth Configuration
- 4.4.18 iSCSI Configuration
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 3.11 Server Mgmt menu
- 4.12 Save & Exit menu
- Chapter 5: RAID Configuration
- Appendix
ASUS E500 G5 SFF
3-19
Ensure to connect the 8-pin power plug.
• For a fully congured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specication 2.0 (or later version) and provides a
minimum power of 300 W.
• DO NOT forget to connect the 8-pin EATX12V1 power plug. Otherwise, the system
will not boot.
• We recommend that you use a PSU with a higher power output when conguring a
system with more power-consuming devices. The system may become unstable or
may not boot up if the power is inadequate.
13. ATX power connectors (24-pin EATXPWR1; 8-pin EATX12V1)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to t these connectors in only one orientation. Find the proper orientation and
push down rmly until the connectors completely t.