User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis stand
- 2.2 Chassis cover
- 2.3 CPU installation
- 2.4 Cooling system installation
- 2.5 System memory
- 2.6 Assembly module
- 2.7 5.25-inch drive
- 2.8 Card reader
- 2.9 3.5” Storage devices
- 2.10 2.5” Storage device
- 2.11 Expansion slots
- 2.12 System fan
- 2.13 BIOS update utility
- 2.14 Motherboard rear and audio connection
- 2.15 Starting up for the first time
- 2.16 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 Trusted Computing
- 4.4.5 ACPI Settings
- 4.4.6 APM Configuration
- 4.4.7 Runtime Error Logging Settings
- 4.4.8 Onboard LAN Configuration
- 4.4.9 Serial Port Console Redirection
- 4.4.10 Intel TXT Information
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 WHEA Configuration
- 4.4.17 Tls Auth Configuration
- 4.4.18 iSCSI Configuration
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 3.11 Server Mgmt menu
- 4.12 Save & Exit menu
- Chapter 5: RAID Configuration
- Appendix
Chapter 3: Motherboard Information
3-18
11. Auxiliary panel connector (20-2 pin AUX_PANEL1)
This connector is for additional front panel features including front panel SMB, locator
LED and switch, chassis intrusion, and LAN LEDs.
• FrontpanelSMB(6-1pinFPSMB)
This 6-1 pin connector is for the front panel SMBus cable.
• LANactivityLED(2-pinLAN1_LED,LAN2_LED)
This 2-pin connector is for the Gigabit LAN activity LEDs on the front panel.
• LocatorLED(2-pinLOCATORLED1,2-pinLOCATORLED2)
This 2-pin connector is for the locator LED1 and LED2 on the front panel. Connect the
Locator LED cables to these 2-pin connector. The LEDs will light up when the Locator
button is pressed.
• LocatorButton/Switch(2-pinLOCATORBTN)
This 2-pin connector is for the locator button on the front panel. This button queries the
state of the system locator.
12. Thermal sensor cable connector (3-pin TR1)
This connector allows you to connect a thermal sensor cable that is used for monitoring
temperature. Connect the thermal sensor cable to the connector and place its probe to
the device that you want to monitor.