User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis stand
- 2.2 Chassis cover
- 2.3 CPU installation
- 2.4 Cooling system installation
- 2.5 System memory
- 2.6 Assembly module
- 2.7 5.25-inch drive
- 2.8 Card reader
- 2.9 3.5” Storage devices
- 2.10 2.5” Storage device
- 2.11 Expansion slots
- 2.12 System fan
- 2.13 BIOS update utility
- 2.14 Motherboard rear and audio connection
- 2.15 Starting up for the first time
- 2.16 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 Trusted Computing
- 4.4.5 ACPI Settings
- 4.4.6 APM Configuration
- 4.4.7 Runtime Error Logging Settings
- 4.4.8 Onboard LAN Configuration
- 4.4.9 Serial Port Console Redirection
- 4.4.10 Intel TXT Information
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 WHEA Configuration
- 4.4.17 Tls Auth Configuration
- 4.4.18 iSCSI Configuration
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 3.11 Server Mgmt menu
- 4.12 Save & Exit menu
- Chapter 5: RAID Configuration
- Appendix
Chapter 3: Motherboard Information
3-16
8. Fan connectors (4-pin CPU_FAN1; 4-pin FRNT_FAN1-3; 4-pin REAR_FAN1)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
• DO NOT forget to connect the fan cables to the fan connectors. Insufcient air ow
inside the system may damage the motherboard components. These are not jumpers!
Do not place jumper caps on the fan connectors!
• Ensure that the CPU fan cable is securely installed to the CPU fan connector.
8. Digital audio connector (4-1 pin SPDIF_OUT1)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.