User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis stand
- 2.2 Chassis cover
- 2.3 CPU installation
- 2.4 Cooling system installation
- 2.5 System memory
- 2.6 Assembly module
- 2.7 5.25-inch drive
- 2.8 Card reader
- 2.9 3.5” Storage devices
- 2.10 2.5” Storage device
- 2.11 Expansion slots
- 2.12 System fan
- 2.13 BIOS update utility
- 2.14 Motherboard rear and audio connection
- 2.15 Starting up for the first time
- 2.16 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 Trusted Computing
- 4.4.5 ACPI Settings
- 4.4.6 APM Configuration
- 4.4.7 Runtime Error Logging Settings
- 4.4.8 Onboard LAN Configuration
- 4.4.9 Serial Port Console Redirection
- 4.4.10 Intel TXT Information
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 WHEA Configuration
- 4.4.17 Tls Auth Configuration
- 4.4.18 iSCSI Configuration
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 3.11 Server Mgmt menu
- 4.12 Save & Exit menu
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-24
• Do not unplug portable disk, power system, or short the CLRTC jumper while BIOS
update is ongoing, otherwise update will be interrupted. In case of interruption, please
press and hold the BIOS_FLBK button for 3 seconds again to restart the process.
• If the light ashes for ve seconds and turns into a solid light, this means that the
BIOS Flashback is not operating properly. Please check the following when this
happens:
- The USB drive should only contain a single partition.
- The USB drive should be formatted to a FAT32, FAT16, or NTFS lesystem.
- The BIOS lename should be correctly named, and in the root folder of the USB
drive.
- If the problem persists, the USB drive may not be compatible, please try another
USB drive of a different brand/model.
Then retry the ashback by pressing the BIOS ashback button for three seconds until
the Flashback LED starts to blink
.
• Refer to section 3.4 Onboard LEDs for more information of the Flashback LED.
• For more BIOS update utilities in BIOS setup, refer to the section 4.1 Managing and
updating your BIOS in Chapter 4.