User Manual

Table Of Contents
Chapter 2: Hardware Setup
2-16
2.10 2.5” Storage device
The server system supports a 2.5-inch storage device via the assembly module.
To install a 2.5-inch storage device to the right HDD bay:
1. Remove the assembly module from
the chassis. Refer to 2.6.1 Removing
the assembly module for more
information.
2. Align the storage device with the
screw holes on the 2.5” storage
device cage, then place the storage
device in to the cage.
3. Secure the storage device to the
cage using the bundled four (4)
screws.
4. Insert and carefully push the cage
into the bay until its screw holes align
with the holes on the bay.