User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Setup
- 2.1 Chassis stand
- 2.2 Chassis cover
- 2.3 CPU installation
- 2.4 Cooling system installation
- 2.5 System memory
- 2.6 Assembly module
- 2.7 5.25-inch drive
- 2.8 Card reader
- 2.9 3.5” Storage devices
- 2.10 2.5” Storage device
- 2.11 Expansion slots
- 2.12 System fan
- 2.13 BIOS update utility
- 2.14 Motherboard rear and audio connection
- 2.15 Starting up for the first time
- 2.16 Turning off the computer
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 Power & Performance
- 4.4.3 Server ME Configuration
- 4.4.4 Trusted Computing
- 4.4.5 ACPI Settings
- 4.4.6 APM Configuration
- 4.4.7 Runtime Error Logging Settings
- 4.4.8 Onboard LAN Configuration
- 4.4.9 Serial Port Console Redirection
- 4.4.10 Intel TXT Information
- 4.4.11 PCI Subsystem Settings
- 4.4.12 USB Configuration
- 4.4.13 Network Stack Configuration
- 4.4.14 CSM Configuration
- 4.4.15 NVMe Configuration
- 4.4.16 WHEA Configuration
- 4.4.17 Tls Auth Configuration
- 4.4.18 iSCSI Configuration
- 4.5 Chipset menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Monitor menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 3.11 Server Mgmt menu
- 4.12 Save & Exit menu
- Chapter 5: RAID Configuration
- Appendix
Chapter 2: Hardware Setup
2-14
2.9 3.5” Storage devices
The server system supports two (2) 3.5-inch storage devices via the assembly module.
To install a 3.5-inch storage device to the right storage bay:
3. Secure the storage device with two (2)
screws into the screw holes on the
right side of the assembly module.
4. Connect the SATA cable to the
SATA connector of the drive.
5. Connect a SATA power cable from
the power supply to the power
connector of the drive.
6. Reinstall the assembly module and
front panel cover. Refer to 2.6.2
Replacing the assembly module and
front cover for more information.
Screw holes
1. Remove the assembly module from
the chassis. Refer to 2.6.1 Removing
the assembly module for more
information.
2. Insert and carefully push the storage
device into the bay until its screw
holes align with the holes on the bay.