User's Manual

Single Board Computer 71
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates
the beginning.) The standard setting is 1 stop bit. Communication with
slow devices may require more than 1 stop bit.
Conguration options: [1] [2]
Flow Con
trol
Flow control can prevent data loss from buer overow. When sending
data, if the receiving buers are full, a “stop” signal can be sent to stop
the data ow. Once the buers are empty, a “start” signal can be sent
to re-start the ow. Hardware ow control uses two wires to send start/
stop signals.
Conguration options: [None] [Hardware RTS/CTS]
VT-UTF8 Comb
o Key Support
Allows you to enable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Conguration options: [Disabled] [Enabled]
Recorder Mo
de
With this mode enabled only text will be sent. This is to capture
Terminal data.
Conguration options: [Disabled] [Enabled]
Resolution 100x31
Allows y
ou to enable or disable extended terminal resolution.
Conguration options: [Disabled] [Enabled]
Putty Ke
ypad
This allows you to select the FunctionKey and Keypad on Putty.
Conguration options: [VT100] [Intel Linux] [XTERMR6] [SCO] [ESCN]
[VT400]
Legacy Console Redirection Settings
Redirection COM Port
Allows you to select a COM port to display redirection of Legacy OS and
Legacy OPROM Messages.
Conguration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6]