User Guide

8 ASUS High-Speed CD-ROM Drive User’s Manual
II. HARDWARE INSTALLATION
II. H/W INSTALLATION
Rear Panel
Rear Panel Features
➀
➁
➂
➃➄
➅
➀ Power Supply connector connects the CD-ROM Drive to the computer’s power
supply.
➁ IDE Interface connector connects the CD-ROM Drive to the 40-pin interface
cable.
➂ Device configuration jumper allows you to set your CD-ROM Drive as the
Master or Slave drive. The default setting is Slave, wherein the jumper is on
“SLAVE”. “CABLE SELECT” is reserved and should not be used.
➃ Analog Audio line out connector has two channels, right (“R”) and left (“L”)
audio outputs, and allows you to direct audio output from your CD-ROM Drive
to your sound card when connected using a CD audio cable. “G” is for Ground.
➄ Digital Audio output connector offers high quality audio effect by outputting
digital signal to a D/A converter or for recording to a digital audio tape (DAT) or
professional audio recording system. The connector follows the EBU-IEC958
standard set by the European Broadcast Union.
➅ Testing jumpers are reserved for manufacturer’s internal testing or diagnostic
purposes.
Pin Definitions
+5V
O
G
O
G
O
+12V
O
DIGITAL
AUDIO
D
O
G
O
ANALOG
AUDIO
CABLE SELECT
SLAVE
MASTER
OO
O
39
40
1
2
IDE INTERFACE
POWER
G
O
R
O
G
O
L
O
D: Digital; G: Ground; R: Right audio channel; L: Left audio channel
NOTE: The pin settings or definitions of the connectors and jumpers are
also engraved on the Rear Panel of your CD-ROM Drive.