Configuration Guide
Rev1.0
2. If your ADSL connection is not detected or your actual connection is not as detected one,
please click Manual Setting.
a) Select your Country and ISP and click Next. If your country and ISP are not on the
list, select Not List, key in your VPI and VCI values. Most of ISPs use encapsulation
mode “LLC”, click Next. In this case, you can refer to the table below or contact your
ISP for VPI/VCI values.
ISP VPI/VCI Connection Type Encapsulation Mode Username format example
Bigpond 8/35 PPPoE LLC
username@bigpond
username@bigpond.com
username@bigpond.net.au
username@direct.telstra.net
Optus 8/35 PPPoE LLC username@optusnet.net.au
AAPT 8/35 PPPoE LLC username@aapt.net.au
iiNet 8/35 PPPoE LLC
Enter username and your
password.
iPrimus 8/35 PPPoE LLC
Enter username and your
password.
PPPoE LLC
TPG 8/35
IPoA LLC
Enter IP address, Subnet Mask,
Gateway and DNS as instructed
by TPG.
PPPoE LLC
Enter username and your
password.
OzEmail 8/35
PPPoA VC/MUX
PPPoE LLC
Enter your username and your
password.
PPPoA VC/MUX
Internode 8/35
IPoA LLC
Enter IP address, Subnet Mask,
Gateway and DNS as instructed
by Internode.
Dodo 8/35 PPPoE LLC user@dodo.com.au
iHug 8/35 PPPoE LLC
Enter username and your
password.
PPPoE LLC username@dsl.pacific.net.au Pacific
Internet
8/35
PPPoA VC/MUX username@dsl.pacific.net.au
Xtra - New
Zealand
0/100 PPPoA VC/MUX