User's Manual
Table Of Contents
- 1 Getting to know your ADSL modem router
- 2 Getting started
- 3 Configuring the General settings
- 4 Configuring the System settings
- 5 Logout & Reboot
- Appendix A - Firewall
- Appendix B - Pin Assignments
- Appendix C – Specifications
- Appendix D - SSH Client
- Appendix E - Connection Setup
- Appendix F - WPS OPERATION
- Appendix G
51
To add a lter (to allow incoming IP trac), click the Add button.
On the following screen, enter your lter criteria and then click
Apply/Save.
Consult the table below for eld descriptions.
Field Description
Filter Name The lter rule label.
IP Version Select from the drop down menu.
Protocol TCP, TCP/UDP, UDP, or ICMP.
Policy Permit/Drop packets specied by the
rewall rule.
Source IP address Enter source IP address.
Source Port (port or port:port) Enter source port number or range.
Destination IP address Enter destination IP address.
Destination Port (port or port:port) Enter destination port number or range.
At the bottom of this screen, select the WAN and LAN Interfaces to
which the lter rule will apply. You may select all or just a subset.
WAN interfaces in bridge mode or without rewall enabled are
not available.