User's Manual
Table Of Contents
- 1 Getting to know your ADSL modem router
- 2 Getting started
- 3 Configuring the General settings
- 4 Configuring the System settings
- 5 Logout & Reboot
- Appendix A - Firewall
- Appendix B - Pin Assignments
- Appendix C – Specifications
- Appendix D - SSH Client
- Appendix E - Connection Setup
- Appendix F - WPS OPERATION
- Appendix G
143
PPPoE clients, otherwise disable it. The DSL-N12HP supports pass-
through PPPoE sessions from the LAN side while simultaneously
running a PPPoE client from non-PPPoE LAN devices.
ENABLE IGMP MULTICAST PROXY
Tick the checkbox to enable Internet Group Membership Protocol
(IGMP) multicast. This protocol is used by IPv4 hosts to report
their multicast group memberships to any neighboring multicast
routers.
NO MULTICAST VLAN FILTER
Tick the checkbox to Enable/Disable multicast VLAN lter.
Enable WAN interface with base MAC
Enable this option to use the router’s base MAC address as the
MAC address for this WAN interface.
3. Choose an interface to be the default gateway.
Click Next to continue or click Back to return to the previous step.
Select DNS Server Interface from available WAN interfaces OR
enter static DNS server IP addresses for the system. In ATM mode,
if only a single PVC with IPoA or static IPoE protocol is congured,
Static DNS server IP addresses must be entered.