User manual
22
DSL-N10S Chapter4:ConguringviathewebGUI
To configure the Internet settings:
1. Click Interface Setup > Internet tab.
2. In the AMT VC dropdown list, select the virtual circuit, and key in the virtual
path values for the asynchronous transfer mode ranging from 0 to 255 in the
VPI eld, and the VCI values ranging from 1 to 65535.
3. In the IPv4/IPv6 eld, select IPv4, IPv4/IPv6 or IPv6.
4. In the Encapsulation item, select Dynamic IP Address, Static IP address,
PPPoA/PPPoE or Bridge Mode.
To configure the PPP settings:
1. In the User Name and Password elds, key in the user name and password
provided by your ISP.
2. In the Connection Settings list, you can select Always On
(Recommended), Connect on Demand, or Connect Manually. If you select
Connect on Demand type, key in the time of inactivity (in minutes) when the
Internet connection is automatically disconnected.
3. Click SAVE to apply the settings made.