User's Manual

4. In the WPS Method eld, select Push Button or Client PIN

code. If you select Push Button, go to step 5. If you select

Client PIN code, go to step 6.

5. To set up WPS using the router’s WPS button, follow these

steps:

a. Click Start or press the WPS button found at the rear of the

xDSL modem router.

b. Press the WPS button on your wireless device. This is

normally identied by the WPS logo.

NOTE: Check your wireless device or its user manual for the location of

the WPS button.

c. The xDSL modem router will scan for any available WPS

devices. If the xDSL modem router does not nd any WPS

devices, it will switch to standby mode.

6. To set up WPS using the Client’s PIN code, follow these steps:

a. Locate the WPS PIN code on your wireless device’s user

manual or on the device itself.

b. Key in the Client PIN code on the text box.

c. Click Start to put your xDSL modem router into WPS survey

mode. The router’s LED indicators quickly ash three times

until the WPS setup is completed.