Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
2-36 Chapter 2: Hardware information
8. P1V5 setting (3-pin P1V5_SEL1)
This jumper allows you to adjust the voltage supply for the FB-DIMM. If
you are installing the low-voltage FB-DIMMs, move the jumper cap to
corresponding pins.
®
DSEB-D16 Series P1V5 setting
P1V5_SEL1
1.5V
(Default)
1.1V
2 31 2
9. P1V8 setting (3-pin P1V8_SEL1)
This jumper allows you to adjust the voltage supply for the FB-DIMM. If
you are installing the low-voltage FB-DIMMs, move the jumper cap to
corresponding pins.
®
DSEB-D16 Series P1V8 setting
P1V8_SEL1
3
2
1.55V
3
4
1.2V
1
2
1.8V
(Default)