Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
ASUS DSEB-D16 Series 2-31
The optional ZCR card for DSEB-D16/SAS onboard LSI 1068 SAS controller is
LSI MegaRAID SAS 8300XLP card. Visit the LSI LOGIC website (www.lsilogic.
com) for more information.
4. Place the lm on the ZCR card
to prevent a possible short
circuit.
5. Place a screw to secure the
riser card to the motherboard
and the chassis.
For 2U server system or above
To install and secure the ZCR card to the motherboard:
1. Unscrew the metal bracket that
comes with the ZCR card and
use that screw to secure the
metal card bracket holder from
the package to the ZCR card.
2. Firmly intsall the ZCR card to
the PCIX slot.
3. Place a screw to secure the
ZCR card to the motherboard
and the chassis.
2.5.7 SODIMM socket
The SODIMM socket on the motherboard
supports an ASUS
®
Server Management
Board 3 Series (ASMB3).
SODIMM socket