Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
2-26 Chapter 2: Hardware information
5. Connect the fan cable to the
4-pin connector labeled FBD_FAN1.
4. Position top cover over the fan
base. Insert the top cover legs into
the slot on the fan base legs.
Push down carefully until the legs
are securely in place and the top
cover hooks snap in place.
Make sure the cables pass
through the notch on the fan base
as shown.
6. Repeat the previous instructions to install the other FB-DIMM fan if needed.