Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
ASUS DSEB-D16 Series 2-25
The FB-DIMMs generate heat during continued operation.
To ensure optimum
thermal condition and performance, install the optional MemCool FB-DIMM fan.
To install the optional FB-DIMM fan:
1. Locate the three FB-DIMM fan holes
on the motherboard.
2.4.6 Installing the MemCool FB-DIMM fan (optional)
2. Disengage the fan top cover from the
fan base. You can do this by rmly
gripping the top cover by the clamps
to release the hooks, then pull up the
top cover carefully until it separates
from the fan base.
DO NOT remove the fan from the
fan base.
3. Position the fan base over the
DIMMs, and insert the fan base
legs into the FB-DIMM holes until
the legs are securely in place.
Top cover
hook
Top cover
clamp
Fan
base