Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
2-12 Chapter 2: Hardware information
3. Lift the load lever in the direction of
the arrow to a 135º angle.
4. Lift the load plate with your
thumb and forenger to a 100º
angle (A), then push the PnP
cap from the load plate window
to remove (B).
To prevent damage to the socket pins, do not remove the PnP cap unless you
are installing a CPU.
5. Position the CPU over
the socket, making sure
that the gold triangle
is on the bottom-left
corner of the socket.
The socket alignment
key should t into the
CPU notch.
Alignment key
Gold triangle mark
Load plate
A
B
2. Press the load lever with your thumb (A), then move it to the left (B) until it is
released from the retention tab.
Retention tab
Load lever
This side of the socket box
should face you.
PnP cap
A
B