Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
6-10 Chapter 6: Driver installation
2. At the
boot:
, type
linux dd
, then press <Enter>.
4. Right-click the
RAID controller
driver item, then select
Properties
from the
menu.
5. Click the
Driver
tab, then click the
Driver Details
button to display the RAID
controller drivers.
6. Click
OK
when nished.
Red Hat
®
Enterprise
To install the Intel
®
6321ESB LSI Logic Embedded SATA RAID controller driver
when installing Red Hat
®
Enterprise OS:
1. Boot the system from the Red Hat
®
Installation CD.
When installing a Red Hat 2.4 kernel with a Driver Update Disk (DUD) to a disk
drive attached to a LSI HBA, use the command below at the install prompt:
linux dd updates.