Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
6-6 Chapter 6: Driver installation
6.1.2 Installing the RAID controller driver
Windows
®
2000/2003 Server OS
When installing the LSI 1068 driver to your OS, make sure the driver you are
installing supports your current installed OS. We STRONGLY RECOMMEND
that you use the LSI 1068 SAS utility bundled in the support CD to create a
driver disk. Refer to page 6-1 for more information.
During Windows
®
2000/2003 Server OS installation
To install the RAID controller driver when installing Windows
®
2000/2003
Server OS:
1. Boot the computer using the Windows
®
2000/2003 Server installation CD.
The Windows
®
2000/2003 Setup starts.
2. Press <F6> when the message “Press F6 if you need to install a third party
SCSI or RAID driver...” appears at the bottom of the screen.
3. When prompted, press <S> to specify an additional device.