Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
5-34 Chapter 5: RAID conguration
5.3.3 Creating a RAID 10 set (Stripe + Mirror)
To create a RAID 10 set:
1. From the utility main menu, select
1. Create RAID Volume
, then press
<Enter>. This screen appears.
Intel(R) Matrix Storage Manager Option ROM v5.6.2.1002 ESB2 wRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
[ CREATE ARRAY MENU ]
[ DISK/VOLUME INFORMATION ]
Enter a string between 1 and 16 characters in length that can be used
to uniquely identify the RAID volume. This name is case sensitive
and cannot contain special characters.
Name:
RAID Level:
Disks:
Strip Size:
Capacity:
Volume1
RAID10(RAID0+1)
Select Disks
128KB
0.0 GB
Create Volume
[
↑↓
]-Select [ESC]-Exit [ENTER]-Select Menu
2. Enter a name for the RAID 10 set, then press <Enter>.
3. Highlight
RAID Level
, press the up/down arrow key to select
RAID 10
(RAID0+1)
, then press <Enter>.
4. Follow steps 4 to 9 of section
5.3.1 Creating a RAID 0 set (striped)
to create
the RAID 10 set.