Computer Hardware User Manual
Table Of Contents
- DSEB-D16 Series specifications summary
- Typography
- About this guide
- Safety information
- Notices
- Product introduction
- Hardware information
- Powering up
- BIOS setup
- RAID configuration
- 5.1 Setting up RAID
- 5.2 LSI Software RAID Configuration Utility
- 5.2.1 Creating a RAID 0 or RAID 1 set
- 5.2.2 Creating a RAID 10 set
- 5.2.3 Adding or viewing a RAID configuration
- 5.2.4 Initializing the logical drives
- 5.2.5 Rebuilding failed drives
- 5.2.6 Checking the drives for data consistency
- 5.2.7 Deleting a RAID configuration
- 5.2.8 Selecting the boot drive from a RAID set
- 5.2.9 Enabling the WriteCache
- 5.3 Intel® Matrix Storage Manager Option ROM Utility
- 5.4 Global Array Manager
- 5.5 LSI Logic MPT Setup Utility (DSEB-D16/SAS model only)
- Driver installation
- Reference information
5-26 Chapter 5: RAID conguration
Using the Objects command
To check data consistency using the
Objects
command:
1. From the
Management Menu
, select
Objects
, then select
Logical Drive
from the menu.
2. Use the arrow keys to select the logical drive you want to check, then press
<Enter>.
3. Select
Check Consistency
from the pop-up menu, then press <Enter>.
4. When prompted, use the arrow keys to select
Yes
from the dialog box to
check the drive.
5. When checking is complete, press any key to continue.