User Manual

2-40 Chapter 2: Hardware information

To connect the mini-SAS cable:

Plug in the mini-SAS cable to the

mini-SAS connector until the cable

lock snaps in place.

To disconnect the mini-SAS cable:

1. With your thumb, push down the

cable lock to release.

2. While still keeping your thumb’s

grip on the cable lock, carefully pull

away the cable from the connector

6. USB connector (10-1 pin USB34)

This connector is for USB 2.0 ports. Connect the USB module cable to

this connector, then install the module to a slot opening at the back of the

system chassis. This USB connector complies with USB 2.0 specication that

supports up to 480 Mbps connection speed.

The USB port module is purchased separately.

DSBF-D12 Series USB connector

USB34

Power

PIN1

USB PortA(-)

USB PortA(+)

GND

Power

USB PortB(-)

USB PortB(+)

GND